Updates
Install a new version of the device’s software, signed by PHNTM.
How to
Update from a USB stick
- Ask [email protected] for the update file. Download it on any computer.
- Copy it to a USB stick (FAT32 or exFAT). Put it in the stick’s top folder, not inside another folder. Do not rename it.
- Plug the stick into PHNTM One.
- On the device, tap Device → Care. Under Updates it says it found an update on the USB stick.
- Tap Copy it here and enter your device password. Leave the stick in until the screen says the update is copied.
- Tap Check this update. The device checks the signature and every file. Nothing changes yet.
- Tap Install. Read the note and tap Install again. Enter your device password.
- Wait a few minutes. Keep the device plugged in.
Update from your paired phone
- On your paired phone, open System & health → Send an update.
- Choose the update file and tap Send to the device.
- On the device, open Device → Care → Updates. Tap Check this update, then Install.
Good to know
- Shipped units have no update channel. The device never looks for updates and never downloads one by itself. Automatic system updates are switched off too.
- Nothing installs without your device password, on the device’s own screen.
- While it installs, the screen says “Installing an update — keep me connected to power”. Do not unplug it.
- After installing, the device restarts its services and tests itself. If the test fails, it puts the previous version back and checks that it works. Your data stays.
- Only one update, restore, factory reset or backup runs at a time.
- Remove deletes an update file that is waiting.
If something goes wrong
| What you see | What to do |
|---|---|
| Update checks did not pass | The file is damaged or not a signed PHNTM update. Tap Remove and ask [email protected] for a new file. |
| Previous version restored | The new version failed its test, so the device went back to the earlier one. You can try again later. |
| Previous version restored; verification still needed | Restart the device, then open Device → Care. If the message stays, contact support. |
| Recovery failed; help is needed | Leave the device switched on. Contact [email protected]. |
| Update failed or Update incomplete | Install the update again. If it fails a second time, contact support. |
| Update stopped because installed files have changed | Contact support before you try this update again. |
| “I’m having trouble starting” after an update | Leave it plugged in. Finishing an interrupted update can take up to about 35 minutes. See If something goes wrong. |
Privacy
The device downloads nothing by itself. An update reaches it only from your USB stick or your paired phone.
Related topics
More detail
Check this update checks the file exactly as an install would: the signature, every file’s fingerprint and which versions are allowed. If the device’s recovery copy is missing, it also accepts the version you already have, so installing it again repairs that copy. Then it shows what is in the update. Install applies it, restarts the services, runs the start-up self-test, and attempts a verified rollback if the self-test fails. If the rollback cannot be verified, the device says that recovery is needed instead of claiming success.
From the device manual for software 0.9.0 (November 15, 2026). Your device serves the manual for its installed software; where this copy and your device differ, your device is right.