Cam · camera preview
Preview a connected camera.
How to
Turn the camera on
- Tap Cam on the left.
- Under Camera source, choose USB camera or Built-in camera.
- Tap Connect camera. ● LIVE shows once a picture arrives.
Turn the camera off
Tap Disconnect. Leaving Cam, or the screen resting or locking, also asks the camera to stop.
Check when the camera was used
- In Cam, open Camera access log.
- Tap Refresh camera log.
Good to know
- Opening Cam does not start the camera. Only Connect camera does.
- Cam is a preview only. It records no sound, sends no pictures to the assistant, and does not watch whether you are there.
- The only photo Cam saves is a Mission snapshot you take yourself. It stays with that Mission step on the device until you delete the mission.
- Tutor's camera is separate: Take a photo of the problem (Learning Lens) saves the page you read with that learner. See Learning Lens.
- The built-in camera (an OV5647 camera module) is on units that have one. A USB webcam works too, if the browser and Linux support it.
If something goes wrong
| What you see | What to do |
|---|---|
| The camera is missing, unplugged or busy | The screen says so. Check the cable, or close the other program that uses the camera. |
| A warning that stopping was not confirmed | Look at the Camera access log. For a USB camera, unplug it to be sure. |
Privacy
Turning the camera off is software control, not a physical shutter. The Camera access log on the device records when the built-in camera was used and the browser-reported USB requests and releases. It holds no pictures and no sound.
Related topics
From the device manual for software 0.9.0 (November 15, 2026). Your device serves the manual for its installed software; where this copy and your device differ, your device is right.